Simply SP-037 Spray Putty 400ml – Fast Drying – Great Adhesion – Corrosion Preventive – Multiple Application

Product Information

Don't spray right up against your print: if you spray too close to your print, you risk getting noticeable drips in the paint job. Use the applicator provided to apply to deep scratches and chips for an even finish that’s easy to paint on. Features & Benefits: Spray putty and primer filler products are readily available from every auto shop or paint supplies distributor.

Fast drying spray putty with excellent coverage to fill small irregularities in surfaces, treated and untreated of wood, metal and aluminium. Treatment: The surface should be clean, dry and free of grease. The aerosol should have room temperature. Best processing temperature 10 to 25°C. The Holts Cataloy Knifing Putty fills surface scratches and stone chips and gives an extra smooth finish prior to painting. This putty is an acrylic-based paste which is suitable for all car finishes and can be used on bare metal, primer or with body filler paste. Think of your 3D prints as the Great Pyramids of Giza. They used to be totally smooth down the side, but age has revealed the layered and rough base built underneath. To make the pyramids smooth, Ancient Egyptians added limestone over the top, since it was a much softer material than the base stone. If they had the technology, they also could have cut away the jagged levels to make smooth, flat faces. This is what finishing consists of; a fine balance between adding and subtracting material to achieve the desired surface finish. The key is to remove enough material to hide some striations (layer lines) and adding just as much to fill in the gaps. Start by sanding with 120 grit sandpaper to bring down some of the surface texture. Before adding more material on top, it’s always better to remove some material first.GREAT ADHESION— our Putty Spray will adhere to most metal and wood, providing a long-lasting effect. Repair filler: specifically for touching up holes and uneven areas on any substrate, inside and out

Although you already know, we've summarised them here again just as a reminder: Filling compounds are divided primarily into mineral fillers (such as gypsum filler) and paste-like dispersion fillers. Generally, manufacturers recommend either product be used for smaller repairs or minor surface imperfections. Both exhibit good adhesion properties and can be used on a range of surfaces like metal, fibreglass, and even wood. Surface preparationDip your piece of 400 grit sandpaper into some water and continue sanding your print. The water helps keep the paper from clogging and gets a much finer finish than dry sanding with the same grit. As you sand, run your fingers over the print to get a feel for how smooth it is. When you think it’s pretty smooth, you're ready for paint.

Europe (Design office) - Unit 10A Chichester Business Park, City Fields Way, Tangmere, W.Sussex PO20 2FT After use, clean the valve (turn aerosol upside down and press the nozzle for approximately 5 seconds). Spot putty is a great material and like any great material, slightly toxic. Gloves are a must as spot putty is basically dye, resin, and talcum powder, and a mask is based on personal preference but always encouraged. The label does list the vapor as harmful, but it's in such small quantities I usually ignore it, although it has given me headaches on several occasions.

The Halfords Primer is essential to obtain the optimum adhesion and performance of the finishing paint. Features & Benefits: Ideally, the work is done while the temperature is above 15°C, but if it is cooler more time is required for drying. Scale of repair work If you need assistance with your delivery please call 01454315588. Our staff will be more than happy to help.